Even using an ice release mechanism can be dangerous, 30 minutes to 4 hours is plenty of time for things to go wrong. There are times when I'm only wanting a short session yet I've underestimated the time to melt. Other times I want a longer session while setting up, but then wished I hadn't used so many cubes while bound.
These problems are easily solved by using your erect penis as a mechanism to trap you in your bindings. I have a couple designs that I use and one more that I'm working on, but for now I'll start with the simplest type.
You'll need some packing tape, a piece of printer paper, some scissors and some string. Cut a piece of paper two inches wide and eight inches long (the width of the printer paper.) Now apply strips of clear packing tape to the paper covering every square inch on both sides. Offset each piece so that you can fold the tape over the edges of the paper which will get rid of any sharp edges.
Now roll the paper into a tube that has a diameter just shy of your fully erect penis. Sizing is important so you may need to try a few times to get it right. I wrap it around my erect penis and then mark where the edge lines up. Then I reduce the diameter by a quarter inch and tape it off. You don't want it to be very tight, the plastic tape will act like bondage tape sticking to your penis when erect but painlessly peeling off when you become flacid. Be sure to tape over the seam on the inside of the tube so that you don't accidentally pinch your penis (unless you'd prefer having the pain.)
Finally take a foot long piece of string, fold it in half, and spiral the ends of the string into a small "disc" of string like so:
You can do this by pinching the ends between your thumb and forefinger and winding the string around itself until you get a flat coil. This can be adhered to the inside of the tube with another piece of tape. Which once your erect penis is filling the inside of the tube, you won't be able to tamper with it.
Because the string is in a hoop, you can add a small key ring with a larks head knot. If your handcuff keys are attached to the tube around your penis, and your hands are tied above your head, the only way to get out would be to wait until your penis is flacid and the tube can be pulled off (using a string that is tied between your cuffs and the tube.)
Or you could anchor your penis to an object that is far away from the keys so you won't be able to go get the keys until you're done with the bondage scene. The best part is that you can get out when you're mentally done with the bondage, so if you're really into the session, it will last a long time. If you're in trouble either serious or you're about to be caught unintentionally, your penis will naturally deflate when your adrenaline starts pumping. I've gone from fully erect to soft in about 20 seconds.
If just knowing you can't get out until you go soft isn't enough to keep you hard, queue up some porn on your TV or computer and either set the sleep timer, or chose a video that's as long as you want. The tube is strong enough to not tear thanks to the tape, and removing the tube in any way without scissors or going flacid will prove to be difficult if not impossible.
Test the tube outside of bondage first. You may find it's too tight and may need to very carefully cut the tube off. Obviously you don't want to put too much tension on your penis or you risk damaging your organ. Check back later for the other alternate designs.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment